Name | Release Date | Size | MD5 | |
---|---|---|---|---|
Serial Control PLUS Manual | v7.0 | Oct 26 2021 | 531.5 KB | ba3eaae8bbd42190b2c5cf537e71e798 |
Serial Control Plus is one of the applications from the all-in-one update project that comes pre-installed on your JNIOR. You only need to enable the Serial Control Plus application to start on boot. In the JNIOR WebUI, in the application section of the configuration tab clicking the checkbox next to Serial Control Plus will enable it to run on boot. You’ll need to restart the JNIOR for this to take affect.

Serial Control Plus runs on the JNIOR and allows the user to interact with the JNIOR I/O via the serial port or the Ethernet port using simple ASCII commands. The user can control the relay outputs (on, off, pulse) and receive the status of the digital inputs and relay outputs (on, off) and counters via the serial port or Ethernet port.
Example commands include:
C1 - Close relay output 1 O234 - Open relays 2, 3 and 4 C* - Close all relay outputs O+2 - Open relay 10 C1p=1000 - Pulse relay 1 closed for 1 second
A device on the network can connect to the JNIOR through Serial Control Plus by setting the TCP/UDP port or enabling serial communication for the application in the Registry Tab of the JNIOR

Related Posts: