The Triggers tab has different types of trigger to react on different signal values. NOTE: Options that are grayed out and in italics are not implemented yet...
A discrete trigger monitors signals of I/O from the JNIOR or its expansion modules. Choosing a trigger to watch a discrete signal can watch if the I/O goes High or Low.
A continuous trigger monitors the signals from the 4-20ma, 10volt, Temperature Probe, or Environmental Sensor. These values are continously being recorded for their values, and are always updating. Choosing a trigger to watch a continuous signal can watch if the signal goes higher, lower, or equal to a certain value.
Monitors the expression entered for the field of this trigger. When the expression evalutes as true, the trigger is activated. This can be used to make a more complex trigger that requires more conditions before activating.
A Single Switch trigger monitors a button press on the Control Panel. This trigger can react to a selected control panel button.
A Multi-Switch trigger monitors when 2 button presses on the Control Panel are pushed at the same time. This trigger can react to a selected combination of 2 control panel buttons.
This trigger monitors any change to a Modbus tag on the JNIOR. When one occurs, this trigger is activated.