This page edits the connection settings for the cinema server client. You can edit serial and tcp settings, set termination strings, and configure responses to recieve from the cinema server client.

*Tcp Port

TCP port that external device can connect on to send data between Device and JNIOR.

*Serial Port

Serial port a Serial Device and Cinema will communicate on.

*Baud

Baud rate for serial connection.

*DataBits

Databits for serial connection.

*Parity

Parity for serial connection.

*StopBits

StopBits for serial connection.

NOTE: the following settings below will not take effect unless a valid TCP port or Serial Port is selected.

Send Unsolicited I/O Alerts

Determines if the serial control application reports changes it makes. Send Counts and Send Date Stamps won't be sent depending on this option.

Send Ack

Allows responses to be sent back to the application through this connection.

Send Counts

Sends the amount of times an input has changed, each time it changes.

Send Date Stamp

Sends the current date and time with each change reported from the serial control application.

*Incoming Termination String

Sets a flag for what sequence of characters represents the end of incoming data.

Outgoing Termination String

Sets a flag for what sequence of characters represents the end of outgoing data.

Enable Serial Commands

Allow commands formatted in Serial Control Format to be accepted. Ex: cp=1000 (pulse output 1 for 1 second.)

   Options with an asterisk (*) next to them means they require a reboot to take affect.